Curtis LCD3957UK - Manual (Page 12)

OSD Menu
Programme Edit
Press
OK the button to enter the Program Edit menu, an example of which is shown below.
Delete: Select a channel and press the RED button, “Delete” will appear on the right of the
program edit menu next to the channel you have chosen, then press the RED button
again and the program will be deleted. However if you decide not to continue to delete
press the menu button to quit.
Move: Select a channel, and press the YELLOW button, then you can use the
and cursor
buttons to change the position of the program, then press the YELLOW again to confirm
the change. Press the menu button to exit and it will automatically save the current setting.
Skip: Select a channel and press the BLUE button to label the channel, as long as the
channel has a skip label it will be skipped when searching through the channels with
the CH+/- buttons.
Rename: Select an ATV channel and press the GREEN button to change the name of the
channel by using the
buttons
FAV: Select a program, press FAV button to set or delete the program as the favorite
channel.
Rename
Signal Information
Displays the signal information in DTV (digital TV) mode only.
Software Update (USB)
Please remove the antenna wire from the TV RF port, go to the Channel Menu, select Software
Update (USB) and press OK to run the software update.
Once the software update is finished, you need to turn off the TV and turn on the TV again to
activate the new software.
WARNING: Do not attempt to use this option unless you have a valid software program for the
GE6805 TV stored on a compatible USB drive, and the drive is connected to the TV.
10