Parkside PSE 2800 A1 - Manual (Page 21)

21 GB/MT
Cleaning, maintenance, storage, transport and ordering replacement parts Cleaning ... / Disposal / Troubleshooting guide / Maintenance schedule
Preparation for transporting
Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suita-
ble canister.
Once it it ready for use, leave the engine running
until the rest of the petrol has been used up.
Empty the engine oil from the engine (as de-
scribed).
Remove the spark plug connector (Fig. M) from
the spark plug.
Secure the device with a tension belt to prevent
it slipping out of place.
ordering spare parts
When ordering replacement parts you should give
the following information:
Type of device
Device article number
Device ID number
Find current information at
www.kompernass.com
note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
Disposal
The packaging is
made of environmentally friendly materi-
als. It can be disposed of at your local
recycling centre.
Do not dispose of
electric equipment in the household waste!
According to European Directive 2012 / 19 / EU,
used electrical devices must be collected and recy-
cled in an environmentally friendly manner.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out devices.
Troubleshooting guide
fault cause remedy
Engine does
not start
Automatic oil
cut-out has not
responded
Check oil level,
top up engine oil
Spark plug
fouled
Clean or replace
spark plug
(electrode
spacing 0.6 mm)
No fuel Refuel / have
the petrol cock
checked
Generator
has too little
or no voltage
Controller or
capacitor
defective
Contact your
dealer
Overcurrent
circuit-breaker
has triggered
Actuate the circuit-
breaker and reduce
the consumers
Air filter dirty Clean or replace
the filter
Maintenance schedule
Please adhere to the following maintenance periods
in order to ensure a failure-free operation.
IMPorTAnT! The equipment must be
filled with engine oil and fuel before it
is started.
Before each
use
After an
operating
period of
20 hours After an
operating
period of
50 hours After an
operating
period of
100 hours After an
operating
period of
300 hours
Checking the
engine oil
X