Parkside PWS 125 B2 - Manual (Page 10)

10
GB
check whether it is damaged or,
use an undamaged attachment
tool. If you have checked the
attachment tool and attached it,
keep yourself and any nearby
persons beyond the level of the
rotating attachment tool and al-
low the device to run for 1 min.
at the highest rotational speed.
Damaged tools usually break during this
test period.
• Wear personal safety equip-
ment. Depending on the appli-
cation, use full face shields, eye
protection or safety goggles. In
so far as it is appropriate, wear
dust masks, ear protection,
gloves or special aprons which
keep small grinding and materi-
al particles away from you. Eyes
should be protected from the foreign
matter which can be caused to fly du-
ring the various applications. Dust or
breathing masks should filter the dust
that is created during operation. If you
are exposed to loud noise for a long
time, you may suffer hearing loss.
• Ensure that other people are at
a safe distance to your working
area. Anyone who enters the
working area should wear per-
sonal protective equipment. Bro-
ken bits from the piece being worked or
broken attachment tools can fly away
and cause injuries even beyond the di-
rect working area.
• Hold the electric tool only by
the insulated gripping surfaces
when performing work in which
the cutting tool may come into
contact with hidden wiring or its
own cord. Contact with a live wire
can also cause a charge in metal parts
of the device and result in an electric
shock.
• Keep the cord away from the ro-
tating attachment tool. If you lose
control of the device, the power cord can
become separated or caught and your
hand or arm may be pulled into the rota-
ting attachment tool.
• Never put the electric tool down
before the attachment tool has
come to a full stop. The rotating at-
tachment tool can come into contact with
the surface upon which it is set, whereby
you could lose control of the electric tool.
• Never allow the electric tool to
run whilst you are carrying it.
Your clothing may accidentally come into
contact with the rotating attachment tool
and get caught and the attachment tool
could drill into your body.
• Clean the ventilation slots of your
electric tool routinely. The motor air
pulls dust into the housing and, should
too much metallic dust collect, could
cause electrical hazards.
• Never use the electric tool near
flammable material. Sparks could
ignite this material.
• Do not use attachment tools
which require liquid coolant. Using
water or another liquid coolant could
lead to electrical shock.
Additional safety instructions
• Connect the appliance only to a power
socket with a residual current circuit
breaker of rated residual current no
more than 30 mA.
• Keep power cords and extension cords
away from the disc. If they are damaged
or cut through, immediately pull the plug