Parkside PKO 400 A1 - Manual (Page 51)

GB/MT
- 51 -
maged parts to ensure that they are in good
working order. Check that the moving parts
are working correctly, that they do not jam,
and that no parts are damaged. Make sure
that all parts are fitted correctly to ensure that
the equipment remains safe to use. Unless
otherwise stated in the operating instructions,
damaged guards and parts have to be re-
paired or replaced by a customer service
workshop. Damaged switches have to be
replaced by a customer service workshop.
Never use an electric power tool with a switch
that cannot be turned on and off.
•
Important!
For your own safety you must only use the
accessories and additional units listed in the
operating instructions or recommended or
specified by the manufacturer. The use of
mounted tools or accessories other than those
recommended in the operating instructions
or catalog may place your personal safety
at risk.
•
Leave all repairs to a qualified electri-
cian
Repairs must be left strictly to qualified electri-
cians or the user might suffer an accident.
•
Noise
Wear ear muffs when you use the compressor.
•
Replacing the power cable
To prevent hazards, leave the replacement of
damaged power cables strictly to the manu-
facturer or a qualified electrician. There is a
risk of electric shock!
•
Inflating tires
Directly after inflating tires, check the pressure
with a suitable pressure gauge, for example
at your filling station.
•
Roadworthy compressors for building
site operations
Make sure that all lines and fittings are sui-
table for the maximum permissible operating
pressure of the compressor.
•
Place of installation
Set up the compressor on an even surface.
•
Make sure that all compressed air lines and
fittings are suitable for the maximum permissi-
ble operating pressure of the compressor.
•
For pressures above 7 bar it is recommended
to use an air line with a safety cable.
2.2 Safety instructions for working with
compressed air and blasting guns
•
The compressor pump and lines can become
very hot during operation. Touching these
parts will burn you.
•
The air which is sucked in by the compressor
must be kept free of impurities that could
cause fires or explosions in the compressor
pump.
•
When releasing the hose coupling, hold the
hose coupling piece with your hand. This way,
you can protect yourself against injury from
the rebounding hose.
•
Wear safety goggles when working with the
blow-out pistol. Foreign bodies or blown off
parts can easily cause injuries.
•
Do not blow at people with the blow-out
pistol and do not clean clothes while being
worn. Risk of injury!
2.3. Safety information for paint spray-
ing
•
Do not process any paints or solvents with a
flash point below 75° C. There is a risk of ex-
plosion!
•
Do not heat up paints or solvents. There is a
risk of explosion!
•
If hazardous liquids are processed, wear pro-
tective filter units (face guards). Also, adhere
to the safety information provided by the ma-
nufacturers of such liquids.
•
The details and designations of the Ordi-
nance on Hazardous Substances, which
are displayed on the outer packaging of the
processed material, must be observed. Addi-
tional protective measures are to be underta-
ken if necessary, particularly the wearing of
suitable clothing and masks.
•
Do not smoke during the spraying process
and/or in the work area. There is a risk of ex-
plosion! Paint vapors are easily combustible.
•
Never set up or operate the equipment in the
vicinity of a fire place, open lights or sparking
machines.
•
Do not store or eat food and drink in the work
area. Paint vapors are harmful to your health.
Anleitung_4010413_LB5.indb 51 Anleitung_4010413_LB5.indb 51 12.03.12 10:19 12.03.12 10:19