Parkside PDSS 310 A1 - Manual (Page 12)

12 GB
After initial use / Maintenance / Cleaning and Care / Troubleshooting Commissioning
First wrap a piece of Teflon tape (not included)
around the outer threads of the plug nipple 9
and the lubricator 11 (see fig. B).
Now screw the plug nipple 9 into the thread
of the lubricator 11 (see Figure C).
Tighten this connection with moderate force
and absolutely using pliers.
Now turn the combination of lubricator 11 and
plug nipple 9 into the connection thread 2
of the impact driver (see Fig. C).
Also retighten this connection with pliers.
Now press the air hose onto the plug nipple
9
using a little force, until the hose locks in.
ATTENTION! Be sure the air hose
is firmly connected. A loose hose
whipping about out of control presents
a major hazard. Also ensure the two screw
connections between lubricator
11 , coupling
and machine are securely seated.
Adjusting the compressed air
Note: this device is designed for an operating
pressure of up to 6.3 bar and a compressor with
the minimum air flow specified in the technical spe-
cifications. When setting the air pressure, remember
the pressure drops by approx. 0.6 bar with a hose
length of 10 m and an inside diameter of 9 mm.
Only use filtered, lubricated and regulated
compressed air.
Adjusting the torque
Set the torque control 3 to the correct torque
by pressing it toward the housing and turning it
until it locks at the desired setting.
Be sure the operating pressure of the compres-
sor is between 5 and 6.3 bar.
Note: the ideal pressure is 6.3 bar. The maximum
torque cannot be reached at a pressure of only 5
bar or with insufficient air flow.
Initial use
Activate the trigger 4 to start the equipment.
Release the trigger 4 to deactivate the equip-
ment.
Setting
1 (low, min.)
2 (normal)
3 (high)
4 (extra high,
max.)
Changing rotation
ATTENTION! The device must come to a
complete standstill before changing the direc-
tion of rotation.
ATTENTION! A machine rotating in an unex-
pected direction can be dangerous. Always
pay attention and use care.
Note: The impact driver clockwise / counter-
clockwise rotation. Use the reverse switch
6
to change the direction of the impact driver.
Pull the bolt forward in the direction of the „F“
marking („Forward / Fasten“) for clockwise
operation. You can now e.g. tighten screws.
Push the bolt back towards the „R“ marking
(„Reverse / Release“) so it protrudes from the
back of the equipment to set to counter-clock-
wise mode. You can now e.g. loosen screws.
Correctly holding the
equipment
This equipment weighs 2.3 kg.
Hold the equipment with both hands to ensure
safe operation (see Fig. D and E).
73786_par_Druckluft-Schlagschrauber PDSS 310 A1_content_LB4.indd 12 31.05.12 12:21