Parkside PMGS 12 B2 - Manual (Page 53)

53 GB
General safety advice for electrical power tools / Operation
CAUtIon! the tool continues to rotate
after it has been switched off!
Avoid contact with rapidly rotating
drill / grinder components.
Securely support the
workpiece. Use clamps or a vice to grip the
workpiece firmly. This is much safer than holding
it in your hand.
never support your-
self by placing your hands near or in
front of the device or the workpiece
surface. A slip can result in injury.
Avoid contact with moving sanding or
grinding tools.
DAnGER oF FIRE FRoM FLyInG
SPARKS! Abrading metal creates
flying sparks. For this reason, always
make sure that nobody is placed in any danger
and that there are no inflammable materials
near the working area.
DUSt HAZARD! Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
noXIoUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Avoid abrading paints containing lead
or other substances hazardous to health.
Do not machine materials containing
asbestos. Asbestos is a known carcinogen.
Do not machine moist materials or
damp surfaces.
notE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off
and allow it to come to a standstill be-
fore you put it down.
Always keep the device
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsible
for their safety. Children must never be allowed
to play with the device.
Q
operation
never use the device for a purpose
for which it was not intended or with
non-original parts / accessories. The use
of tools or accessories other than those recom-
mended in the operating instructions could lead
to you suffering an injury.
Q
Inserting or replacing
a tool / collet
Press the spindle lock 7 and keep it pressed.
Rotate the clamping nut 5 until the lock
engages.
Loosen the clamping nut 5 with the combina-
tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use though the
clamping nut
5 before you insert it into the
collet 18 suitable for the tool shaft.
Press the spindle lock 7 and keep it pressed.
Insert the collet 18 into the threaded insert and
tighten the clamping nut 5 on the thread using
the combination key 23 .
Using the Insertion tool with mandrel 13 :
notE: Use the screwdriver end of the combi-
nation key
23 to release or tighten the screw of
the mandrels 13 .
Insert the mandrel 13 into the electrical tool as
described.
With the aid of the combination wrench 23 ,
unscrew the screw from the mandrel 13 .
Place the insertion tool you wish to have onto
the screw between the two washers.
With the aid of the combination wrench 23 ,
tighten the screw on the mandrel 13 .