Parkside PMGS 12 B2 - Manual (Page 47)

47 GB
Introduction / General safety advice for electrical power tools
6 Spigot nut
7 Spindle lock
Mains adapter (see Fig. A):
8 Plug-in device for plug 4
9 Tray
10 Mains adapter
11 Power cable (with mains plug)
Accessories (see Fig. B):
12 6 hSS drills
13 2 Mandrels for mounting tools
14 3 Polishing wheels
15 4 Grinding wheels
16 1 Metal brush
17 16 Cutting wheels
18 5 Collets
19 2 Plastic brushes
20 3 Milling bits
21 2 Engraving bits
22 5 Grinding bits
23 1 Combination tool
Q
Included items
1 Small drill
1 Mains adapter
1 Plastic case
1 Accessory kit (50-piece)
1 Operating instructions
Q
technical information
Small drill PMGS 12 B2:
Nominal voltage:
12 V
Nominal input: 22 W
Idle-running speed: n
0
5000–20000 min -1
Max. drill bit diameter: ø 3.2 mm
Certified acc. to:
EN60745-1; EN60745-2-1
EN60745-2-3
noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 54.70 dB(A)
Sound power level: 65.70 dB(A)
Uncertainty K: 3 dB
Evaluated acceleration, typical:
hand / arm vibration: 1.868 m / s
2
Uncertainty K = 1.5 m / s 2
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical pow-
er tool is used regularly in particular circumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Mains adapter PMGS 12 B2-1:
InPUt:
Rated voltage:
230 V∼ 50 hz
oUtPUt:
Nominal voltage: 12 V
Nominal current:
1 A
Protection class: II /
Certified acc. to: EN61558
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!