Exabyte EXB-8505 8mm - Manual (Page 83)

Use the READ BUFFER command to copy the new code from a
tape drive across the SCSI bus to an initiator. You can then use the
WRITE BUFFER command to copy the code from the initiator to
another tape drive.
For more information about the CTS Monitor program, refer to the
CTS Monitor documentation. For more information about using SCSI
commands, refer to the EXB-8205 and EXB-8505 SCSI Reference.
Shipping Requirements
This section describes the shipping requirements for the tape drive,
including information about the shipping carton and a list of the
environmental conditions needed for transporting the tape drive.
Shipping Cartons
The tape drive is sealed in a static protection bag and is shipped with
either one drive per carton (single pack) or with three to five drives
per carton (multi-pack).
Table 4-4 shows shipping dimensions and weights for the tape drive.
Size Dimensions Weight
Single-pack 13.5 inches long
×
10.75 inches wide
×
8.5 inches high
(34.3
Ч
27.3
Ч
21.6 cm)
1 CTS: 4.5 lbs (2.0 kg)
Multi-pack 23.25 inches long
×
13.5 inches wide
×
11.5 inches high
(59.1
Ч
34.3
Ч
29.2 cm)
3 CTSs: 12 lbs (5.4 kg)
4 CTSs: 15 lbs (6.5 kg)
5 CTSs: 18 lbs (8.2 kg)
Table 4-4 Single pack and multi-pack shipping dimensions and weights
May 1994 EXB-8205 and EXB-8505 4-19
(Standard and XL)
4 Requirements for Use