Pilot modules – Logitek Electronic Systems Pilot User Manual
Page 23
Pilot Modules
PLT-FADER (Fader Module) – International (non-UK) Layout
CNG – Change button. Press to route a new source to this fader. Use the select knob on the
monitor module to scroll through the sources on the OLED display below the fader. Press Take on
the monitor module to select the source; Cancel to clear change mode. Change mode will also
automatically turn off after 5 seconds of inactivity.
Cue button – Press to listen to the source through the internal cue speaker regardless of fader
position or whether the channel is on or off.
Fader – Adjusts level for the selected mixing busses.
button – Turns channel on
button – Turns channel off
Logitek Pilot Reference Manual
PLT-FADER
Phone 1
Studio A
CUE
P
3
1
2
10
5
5
10
20
30
40
50
60
CNG
P button – Program bus select. Press to send this channel to the program mixing
bus. The lamp on the button will illuminate to show whether the bus is assigned
or not. The lamp will glow at half brightness when the channel is off and full
brightness when the channel is on.
1 button – Aux 1 bus select. Press to send this channel to the Aux 1 mixing bus.
The lamp on the button will illuminate to show whether the bus is assigned or
not. The lamp will glow at half brightness when the channel is off and full
brightness when the channel is on.
2 button – Aux 2 bus select. Press to send this channel to the Aux 2 mixing bus.
The lamp on the button will illuminate to show whether the bus is assigned or
not. The lamp will glow at half brightness when the channel is off and full
brightness when the channel is on.
3 button – Aux 3 bus select. Press to send this channel to the Aux 3 mixing bus.
The lamp on the button will illuminate to show whether the bus is assigned or
not. The lamp will glow at half brightness when the channel is off and full
brightness when the channel is on.
23