Logitek Electronic Systems Pilot - Manual (Page 16)

4 Configuration
This chapter covers basic configuration information, relating specifically to the Pilot surface.
JetStream
setup and configuration is covered in detail in the following manuals:
 Logitek JetStream Reference Manual
 Logitek AEConfig Reference Manual
JetStream Configuration
Configuration of the JetStream Router is done in AEConfig.
Currently, AEConfig does not include specific DSP table entries for the Pilot. You should use a
Mosaic surface of the appropriate size when configuring a Pilot. In the future, specific Pilot support
will be added to AEConfig, however, the two consoles are compatible in DSP allocations.
 See the JetStream Reference Manual for information on configuring JetStreams.
CommandBuilder Triggers
The Pilot surface contains many programmable buttons and features. These features are scripted in
“triggers” in CommandBuilder, and executed by JetStream Server, which is included with the
JetNet Audio Networking Module.
 See the CommandBuilder User’s Manual for information on writing Triggers.
The CommandBuilder manual includes details and examples of Pilot specific features, such as
Monitor Hotkeys, Bridge Buttons and more. The programming of these features does require a
certain level of familiarity with the system. If you need assistance, please contact Logitek Electronic
Systems or your reseller.
Logitek Pilot Reference Manual 16