Logitek Electronic Systems Pilot - Manual (Page 11)

LED Meter (PLT-MTR)
A hardware LED Meter is available as an option. The Meter includes two high-resolution meters –
one for Program bus and one switched (follows Monitor selection).
 TIP: If the Pilot is powered on without being connected to the JetStream, all meter LEDs
will illuminate. This is normal operation; the LEDs will turn off after being
connected to the JetStream and the console begins to receive meter data.
Mounting
 The Meter option is supplied separately and attaches to the back of the Pilot frame with two
screws (included).
 The ribbon cable from the Meter attaches to an internal header via a small ribbon cable. The
blue side of the ribbon cable should be up. Pass the ribbon cable through the frame and
push the ribbon into the connector until it comes to a stop and gently close the brown latch
on top of the ribbon cable. Take care to not use much force on this connector as it is very
fragile.
 The Meter is not designed to be attached in another location.
Dimensions
 8.2” W x 2” H x 0.5” D (208.28 mm x 50.8 mm x 12.7 mm)
 The standard mounting adds 2.07” (52.5mm) to the height
Logitek Pilot Reference Manual
Figure 1: Pass the ribbon cable through the frame Figure 2: Gently snap the latch onto the cable.
11