Bang & Olufsen BeoCom 2 - Getting Started - Manual (Page 18)

18
For your information…
For the Canadian market only…
NOTICE: The Industry Canada label identifies certified
equipment. This certification means that the equip-
ment meets telecommunications network protective,
operational and safety requirements as prescribed
in the appropriate Terminal Equipment Technical
Requirements document(s). The Department does not
guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities
of the local telecommunications company. The
equip ment must also be installed using an accept-
able method of connection. The customer should
be aware that compliance with the above conditions
may not prevent degradation of service in some
situations. Repairs to certified equipment should
be coordinated by a representative designated by
the supplier. Any repairs or alterations made by the
user to this equipment, or equipment malfunctions,
may give the tele communications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power util-
ity, telephone lines and internal metallic water pipe
system, if present, are connected together. This pre-
caution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such
connections themselves, but should contact the ap-
propriate electric inspection authority, or electrician,
as appropriate.
NOTICE: The Ringer Equivalence Number (REN)
assigned to each terminal device provides an indica-
tion of the maximum number of terminals allowed to
be connected to a telephone interface. The termina-
tion on an interface may consist of any combination
of devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5.
To prevent radio interference to the licensed service,
this device is intended to be operated indoors and
away from windows to provide shielding. Equipment
(or its transmit antenna) that is installed outdoors is
subject to licensing.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.