Bang & Olufsen BeoSystem 3 Getting Started User Manual

Page 27

tio

First-time setup of loudspeakers
applies only to speakers for TV viewing.
See the Guide for further information.

Adjust volume, bass, treble and

loudness and preset two default
speaker combinations.

Calibrate the speakers

Set up the speakers to optimise sound from your 

listening position. To enjoy Adaptive Sound 

Technology several speakers and a Beo6 remote 

control are necessary. 

Disable or enable Adaptive Sound Technology

*Navigation button

Projector

If you have a Beo4 without navigation button or if your Beo4 is not set to the 
correct mode, you cannot enable the navigation button. See the Beo4 guide 
or contact your Bang & Olufsen retailer for further information. 
If you have connected a projector and not a screen, you must switch off the 
television after first-time setup and then switch it on again for your settings to 
take effect. 

Make settings for each LISTENING
PRESET. See the Guide for further
information.

NOTE! For further information about remote 
controls and first-time setup, see the Guide. 

Make standby settings for the TV

Make standby settings

Set the TV to switch itself to standby after some
time with no operation or switch power saving on

or off. See the Guide for further information.

AST ON:

SPEAKER SETUP

TV LISTENING PRESET

CINEMA LISTENING PRESET

SOUND ADJUSTMENT

SOUND SETUP

AST ON/OFF

AST OFF:

SPEAKER TYPES
SPEAKER ROLES
SPEAKER DISTANCE
SPEAKER LEVEL

SOUND ADJUSTMENT

STANDBY SETTINGS