Bang & Olufsen BeoSystem 3 Getting Started - Manual (Page 26)

First-time setup of your television
TV tuner
Connections
Power saving
The TUNING menu is only available if the TV tuner is enabled, see the Guide
for further information.
Select the type of equipment connected to each socket, the sockets used, the
product name, and the source name.
If you have other equipment connected to your television, set POWER SAVING
to OFF. See the Guide for further information.
Information
This first-time setup procedure is activated when the TV is connected to the mains
and switched on for the first time. If you want to change your setup at a later date,
you can access the same menus and update your settings.
Switch on the TV
Select settings
You are led through the following settings only
when you switch on the TV for the first time.* 1
However, the sequence of menus depend on the
connections and settings you make.
It takes the TV approx. 20 seconds to start up and
become ready for use. Switch on
Select setting Accept and go to next menu item
Set the on-screen menu language
Disable or enable the navigation button on your remote control*
2
Disable or enable internal TV tuner or DVB
Register connected equipment
Tune in TV channels automatically. Available only if the TV tuner is enabled.
See the Guide for further information.
1 *NOTE! When you have selected the preferred
settings in a menu, you may have to press the
green button to continue to the next menu in the
first-time setup procedure. Follow on-screen
instructions.
or
TV
MENU LANGUAGE
REMOTE CONTROL
TUNER SETUP
CONNECTIONS
AUTO TUNING
26