Lanner LEC-2055 - Manual (Page 19)

19
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Wall Mounting
The product does not ship with wall mounting kit. You
could purchase the wall mounting kit from Lanner as an
accessory. To mount your product on the wall, follow the
instructions below:
First make a hole for the anchor in the surface on the 1.
wall. Use the following diagram as a guideline for
placing the anchors.
Then press the anchor into the hole until it is flush with
2.
the surface. You may need a hammer to tap the wall
anchor.
Use a screwdriver to screw the threaded screw into the
3.
plastic anchor.
Attach the wall mounting bracket to the back of the
4.
device, securing it in place with four of the flat-head
screws provided.
Hang the device on the wall.
5.