Lanner LEC-2055 - Manual (Page 18)

18
Hardware Setup
Chapter 4
Embedded and Industrial Computing
Installing the Hard Disk
The system can accommodate one Serial-ATA disk. Follow
these steps to install a hard disk into the system:
Place hard disk on the hard disk tray of the top cover 1.
and align the holes of the hard disk with the mounting
holes on the tray.
Fix the hard disk on the hard disk tray by using 4
2.
mounting screws
Plug the Serial-ATA cable to the hard disk.
3.
Connect the Serial-ATA power and data disk cables to 4.
the Serial-ATA power and disk connectors on the main
board respectively.
Unit: mm
Connecting Power
Connect the LEC-2055 to a 12~36 VDC power source.
The DC power-in connector comes with a 2-pin terminal
block for its Phoenix contact. This power socket can only
accept the power supply with the right pin contact so be
cautious when inserting power to the system.
4
3
2 1
+ -
DC IN