Lanner MR-330A - Manual (Page 8)

6
Hardware Setup
Chapter 2
Network Application Platforms
Installing the Hard Disk
The system can accommodate one 2.5” Serial-ATA disks.
Follow these steps to install a hard disk into the MR-330A:
Unscrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the holes
2.
of the hard disk with the mounting holes of the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA power (the SATA power
4.
cable is attached to the power supply unit) and data
cables to the hard disk’s power and drive connectors
respectively.
Plug the Serial-ATA data cable to the Serial-ATA
5.
Connector on the main board.
Put the hard disk tray with the installed hard disk back
6.
and fasten it to the system with the mounting screws.
3
5
4
6