Lanner FW-8895 - Manual (Page 14)

10
Introduction
Chapter 2
Network Application Platforms
Installing the system to the rack
1. Extend the rails until they lock into place.
2. Holding the system with its front facing you, align the
unit with the extended rails and carefully insert the
system by sliding the inner rail into the outer rail. Push
the chassis all the way toward the back until the front
ear brackets contact the rack. Remember to release
the extension safety lock along the way.
3. You may also fix the front ear brackets (short) to the
rack if the system doesn’t require frequent pulling out
of the rack.
Left side of the system
R a c k -
m o u n t
holes
Front
Installing the Front Rack-Mount Ear Bracket
Attach the front rack-mount (long) brackets. Locate the
threaded holes along sides of the chassis and use the
package of black screws that shipped with the chassis.
1. Align the front rack-mount bracket to one side of the
chassis.
2. Insert and tighten the screws on one side.
3. Repeat the above steps for the other side of the
chassis.
4. Installing the system to the rack