Lanner FW-6486 - Manual (Page 9)

6
Hardware Setup
Chapter 2
Network Application Platforms
Installing a CompactFlash Card
FW-6486 provides one CompactFlash slot slot. Follow the
procedures bellow too install a CompactFlash card.
Align CompactFlash card and the card slot with the 1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
Installing the System Memory
The motherboard supports DDR3 memory that features
data transfer rates of 800 or 1066 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications. It comes with one Double-
Data-Rate Three (DDR3) Small Outline Dual Inline Memory
Modules (SO-DIMM) socket.
Align the memory module’s cutout with the SO-DIMM’s 1.
slot notch.
Install the SO-DIMM.
2.
Note:
SO-DIMM installed must meet the following 1.
speed requirement: DDR3 800 or 1066 MHz. Do
not install DIMMs with different speeds.
The motherboards can support a total memory 2.
capacity of 4 GB in maximum.