Lanner FW-6486 - Manual (Page 6)

3
Introduction
Chapter 1
Network Application Platforms
Front Panel Features
F2 F1 F5
F1 LED
System (Green) Green: when the system is on.
Off: when the system is off.
Status (Green/Amber) It is a programmable LED to show the operating status of the system. For
more details, look for the software utility folder in the Driver and User Manual
CD.
Hdd (Yellow) Flashing: when there are data access activities or when the CompactFlash
card or SATA disk (on model FW-6486B only) is present or both
Off: when there is no CF or SATA disk present..
F2 LCM Module
The front LCM module with touch pad can be programmed to show the operating status or to display certain characters
or graphics.
F3 Reset Switch
A hardware (default) or a software reset switch. You will need to set it to either hardware or software reset in the BIOS.
F4 Console Port
It is a console port via RJ45 connector. Using suitable RS-232 cable, you can connect an appropriate device, for example,
a terminal console for diagnostics.
Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit , no flow control.
F5 4 10/100/1000 Gigabit Ethernet Ports
The Gigabit Ethernet ports are provided by Realtek RTL8111E-VB-CG Integrated 10/100/1000 Ultra Gigabit Ethernet
Transceiver through the PCI-e interface. They support both Wake-on-LAN and remote wake-up. They also support the
IEEE 802 IP Layer 2 priority encoding and IEEE 802.1Q VLAN tagging.
LED Indicator LED Function LED Color On Off Blinking
Left Link/Activity Yellow connected Not connected Linking/there is
traffic
Right Data Speed Green
Orange
100 Mbps
1000 Mbps
10 Mbps
F6 USB 2.0 Ports
It connects to any USB devices, for example, a flash drive. Besides this external USB port, there is another one with the
internal pin headers (refer to Jumper Setting on Chapter 3 Motherboard Information)
F7 PCI Expansion Slot
In addition to these two PCI expansion slots, there is also one internal Mini-PCI connector .
F3 F6 F7 F4