Laney LR5 - Manual (Page 18)

Factory Reset:
You can at any time return the amplifier to all its original factory settings.
With the amplifier in the OFF state, hold down the DEL FX Button, turn ON the power switch, continue holding
down the DEL FX Button for a few seconds while all the LED’s flash, then as the LED’s become steady, release the
DEL FX Button & the factory settings are restored.
Amp Model Definitions
Linebacker
Sounds
Tone Description Amp modelled
Crystal Pure & Clean Clean channel of an LC amp - bright and full
Crystal + Clean with Compression Clean channel of an LC amp - bright and full + a clean boost pedal to
give more low end
VC Clean & Warm A VC combo set clean
VC+ 1 x 12" Combo Semi Distorted A VC combo with the drive channel switched to give a semi broken up
tone
Heart 1 x 12" Classic vintage tone Lionheart Combo on the clean channel pushed hard giving you a classic
semi distorted vintage tone
Heart + 1 x 12" Classic vintage distorted tone Lionheart combo with more gain dialled in
Volt Classic rock distortion Tube head and cab combination - set to give you a crunch tone
Volt + Classic rock solo tone Tube head driven hard - more gain dialled in
TI Crushing rhythm tone TI signature head pushed
TI + Hard rock solo tone TI signature head pushed hard
Wreck Insane full on gain Drive channel of a modern valve head - full on!