Laney LR5 - Manual (Page 14)

IN DEPTH
12V DC POWER SOCKET: Connect to your DC Power Supply. Make sure the voltage marked
on the DC Power Supply matches the outlet voltage for your country!
POWER: This is the main power ON/OFF switch. After switch on, all of the LED’s on the fascia light
up momentarily, after a couple of seconds the LED’s indicate the previous
settings used: i.e. If the amp was last used with Chorus & Reverb, the MOD
FX & DEL FX LED’s will be lit. The Power LED will also be lit with the
switch in the ON position..
INPUT JACK: Connect your guitar here. Use only good quality cables to
avoid poor sound quality.
AUX IN JACK: Use this input for CD/MP3 players to allow you to play
along to the music or use as backing. For use with standard stereo 3.5mm
jack leads. The overall volume of your player is controlled by the its own volume control.
(NOTE: This input is not muted when in the guitar tuner is in use).
AMP: This control allows the user to select from the various factory pre
programmed amp models.These are not just guitar amp settings, used as a
starting point, each can be configured as a compilation of amp and/or
EQ/effect set-ups to give some of music’s most inspirational sounds. There
is a vast choice to suit your own style & taste.
(Descriptive table to follow Page 18)
TIP
TIP