Jordan Valve Mark 44 Series – Adjustable Cam - Manual (Page 3)

-3-
Rocker Plates, Etc.
Remove all pressure from the line as outlined in 1.
“Warning” under the Maintenance Section.
Remove the low flow end stop set screw (32) and
2.
rotate the rocker (23) to disengage the stroke stop
bearing (13).
Remove the cotter pin (31), slotted nut (30), and
3.
washer (25). Remove the rocker from the support
stud (26).
The sub-assembly containing the rocker plates, and
4.
support straps (16) & (20) can now be removed from
the rocker and the necessary parts replaced.
Reassemble in reverse order.
5.
Bearing (Rocker) Replacement
Remove all pressure from the line as outlined in 1.
“Warning” under the Maintenance Section.
Remove the low flow end stop set screw (32) and
2.
rotate the rocker (23) to disengage the stroke stop
bearing (13).
Remove the cotter pin (31), slotted nut (30), and
3.
washer (25) and remove the rocker from the sup-
port stud (26).
Press the bearing out of the rocker. A .75” diameter
4.
shaft will be helpful.
Press the new bearing into the rocker and then reas-
5.
semble in reverse order.
Torque Procedure
Caution: Do not over-tighten cap screws.
Install all cap screws hand tight. 1.
Tighten in the order of the pattern shown below to 2.
75-100 in/lbs., (6-8 ft./lbs.) then repeat to 140 in/
lbs. (12 ft/lbs.).
Ordering Spare Parts
Use only genuine Jordan Valve parts to keep your valve
in good working order. So we can supply the parts, which
were designed for your valve, we must know exactly which
product you are using. The only guarantee to getting the
correct replacement parts is to provide your Jordan Rep-
resentative with the valve serial number. This number is
located on the valve identification tag. If the serial number
is not available, the parts needed for your valve might be
determined using the following information: Model num-
ber, Valve Body size, Plug Material and Seat Size, Spring
Range or Set Point, Trim Material, Part Name - Number
and Quantity (see parts list chart).
Note: Without a valve serial number, any parts ordered
incorrectly are subject to a minimum 25% restock charge
when returned.