JBL Synthesis SDP-45 4K - Manual (Page 7)

RI Right information.
UP Up
DN Down
SL Select
EX Exit one menu out, go from Zone to Main See Auto Save below
QS Query status
00 = top (idle) screen
01..99=inside a submenu
DISP Display brightness and Text Display Feedback
ON On
OF Off
01 25% Brightness
02 50% Brightness
03 75% Brightness
04 100% Brightness
L1 Returns Line 1 Send QS or Auto Feedback
ON to receive the text
L2 Returns Line 2
L3 Returns Line 3
L4 Returns Line 4
QS Query Status
ASAV Set auto-save or force save now
00
OFF - any parameter changed will not be automatically
saved in EEPROM. (will require ASAVSV Command to
save!)
01
Automatically saves all Changed parameters(within2s).
Will also force saving of currently modified parameters. Recommended to be sent
on power up.
SV
Forces save all modified parameters, without changing
the auto save status (ON or OFF)
Send this before exiting
the menu setup screens to
force save all changes
QS Query, return auto-save Status
OUTP Query Output Format (Active Speaker Format)
QS query, returns listening output format
The response will show the speaker output currently active. For example: #OUTP7.1\r would
indicate 7.1 speaker output. This does not indicate the decoding or post processing listening
mode but does confirm how many speakers are being used. This will also automatically be sent
without a QS being issued by the SDP-45 as affected by surround or input mode changes.
LMOD Listening Mode These represent output or
post processing after the
analog or digital signal has
2Ch. to 7.1 effects:
00 No Effect