Yaskawa V1000-Series Option SI-EM3D/V Dual Port EtherNet Modbus TCP/IP Technical Manual - Manual (Page 8)

3 Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function properly.
u Option Package Contents
Description Option Unit Ground Wire Warning Labels Installation Manual
–
MANUAL
Quantity 1 4 1 1
u Tools Required for Installation
A Phillips screwdriver (M3, M3.5 to M6 metric or #1, #2 U.S. standard) is required to install the option. Screw sizes vary by
drive capacity. Select a screwdriver appropriate for the drive capacity.
Note: Tools required to prepare the option cables for wiring are not listed in this manual.
3 Receiving
8 YASKAWA SIEP YAICOM 17A V1000 Option Dual-Port Modbus TCP/IP SI-EM3D/V Technical Manual