Testing card installation, Testing the network, On-board indicator lights – Yaskawa SmartTrac PCIM Card User Manual

Page 21

SMART TRAC Genius PCIM Card

Technical Manual 3554-0080 Testing Card Installation

••

Testing Card Installation

Testing the Network

Once installed, check the on-board indicator lights. Normally, both LEDs should
be illuminated.

On-board Indicator Lights

Two LED indicator lights on the Smart Trac Genius PCIM card provide system-
related information:

•

GENI 104 Self-test/Health LED: When ON, indicates that power is
available to the card and the card self-test was successful. When OFF,
indicates a card failure, improper address assignment, or that the /RST
input line is low.

•

Communications LED: When ON, indicates that power is available to
the card and the controller's communications hardware is functional
and can send data (receives the token) every serial bus scan. When
OFF, indicates that an error has been detected in the communications
hardware or while accessing the Genius serial bus.

LED 2 - Communications

LED 1 - GEN 104 OK

PC/104 Connector

Figure 5. Genius Card Connectors and LEDs