Yaskawa SmartTrac PCIM Card - Manual (Page 19)

SMART TRAC Genius PCIM Card
Technical Manual 3554-0080 Configuring the Smart Trac Genius Card
••
15
The Smart Trac Genius card may be set to either enable or disable outputs.
SW1 Optional Settings – Position 8 (Outputs)
Outputs Position 8
Outputs Disabled (default) 0
Outputs Enabled 1
Non-Default Settings for Switch SW2
The Smart Trac Genius card uses two consecutive bytes of I/O space and 16
Kbytes of memory in the host system. I/O and memory locations must not
conflict with any other with other memory or device addresses in use. The Smart
Trac Genius card's switch SW2, positions 1-4, determine the starting address for
16 kbytes of memory that is used to store I/O data, for communications buffers,
and other information.
0 = Off 1 = On
SW2 Optional Settings – Positions 1-4 (Memory Location)
16Kb Data
and Comm.
I/O Starting
Address 1 2 3 4
C800 1 1 1 1
CC00 0 1 0 0
E000 1 0 0 1
E400 0 0 0 1
The I/O registers occupy 2 bytes of space in the host system. The application
software on the host system exchanges data with the Smart Trac Genius card by
reading and writing to the assigned I/O addresses. The host's I/O Base, or
starting, address is set using positions 5, 6 and 7 of SW2.
0 = Off 1 = On
SW2 Non-Default Settings – Positions 5-7 (I/O Base Address)
4-bytes I/O
Memory
Address 5 6 7
360 1 1 1
364 0 1 1
368 1 0 1
36C 0 0 1
3E0 1 1 0
3E4 0 1 0
3E8 1 0 0
3EC 0 0 0
Outputs
Memory Location
I/O Base (Port)
Address