Yaskawa V1000 Option 24 V Power Supply - Manual (Page 21)

5 Installation Procedure
YASKAWA ELECTRIC TOBP C730600 27B V1000 Option PS-V10 Installation Manual 21
◆
Connect the Mounting Attachment (PS-V10S / PS-V10M)
1. The two cables, now connected to the drive, should pass through the center square
opening of the 24 V Power Supply mounting attachment.
2. Align the four tabs on the mounting attachment with the inside edges of the cable access
opening on the drive and gently press and click the mounting attachment into place as
shown in Figure 13 .
Figure 13
Figure 13 Connecting the Mounting Attachment (PS-V10S)
3. Press firmly on the mounting attachment tabs and make sure it is locked into place on the
side of the drive case as shown in Figure 14 .
NOTICE: Make sure connection cables are not pinched between the drive case and the mounting
attachment. Drive damage may occur due to shorted or broken wire connections.
Figure 14
Figure 14 Locking the Mounting Attachment into Place (PS-V10S)
Tab
Press four tabs ensuring
the mounting attachment
is fastened to the drive