Yaskawa V1000 Option 24 V Power Supply - Manual (Page 20)

5 Installation Procedure
20 YASKAWA ELECTRIC TOBP C730600 27B V1000 Option PS-V10 Installation Manual
◆
Unplug Drive Cables to Install the 24 V Power Supply Option
(PS-V10M)
1. Unplug one end of the existing drive cable from its socket inside the drive as shown in
Figure 11 . Press inward on the cable release tab in the center of the cable connector and
use a flat-blade screwdriver to gently pry down to remove the connector from its socket.
NOTICE: Do not use excessive force when using a screwdriver to free the drive cable connection. Failure to
comply may damage or break the cable connectors.
Figure 11
Figure 11 Unplugging the Drive Cable Connection (PS-V10M)
2. Next, plug the supplied 24 V Power Supply Option connection cable into the drive cable
socket and click firmly into position as shown in Figure 12 .
Note: Refer to Table 1 to verify the correct option part number is used with your drive model.
Connection cables and mounting attachments for 24 V Power Supply Options differ depending
on drive model.
Figure 12
Figure 12 Plugging the Option Connection Cable into the Drive (PS-V10M)