Electrolux 76639 - Manual (Page 30)

Operating Instructions
30
What to do if...
Trouble Shooting
If the appliance is not working correctly, please carry out the following
checks before contacting your local AEG Service Force Centre.
Important: If you call out an engineer to a fault listed below, or to
repair a fault caused by incorrect use or installation, a charge will be
made even if the appliance is in guarantee.
• If the fault code E10, E20 or E40 is shown in
the multi-display, you may be able to remedy
the fault yourself (see the Faults table below).
After clearing the fault, press the START/
PAUSE button. If the fault code is displayed
again, contact your local AEG Service Force Centre.
• For all other faults displayed in the multi-display, please contact your
local AEG Service Force Centre, stating the fault code.
Problem Possible Cause Remedy
The washing machine
does not work.
The mains plug is not
plugged in.
Plug in the mains plug.
The house fuse has blown. Replace the fuse.
The door is not correctly
closed. Close the door; The lock must
engage audibly.
START/PAUSE button not
pressed long enough.
Keep the START/PAUSE but-
ton pressed until the pro-
gram begins.
Door cannot be closed. The child safety feature is set
Cancel the child safety fea-
ture (see Section "Child
Safety Feature“).
The fault code E40
appears. The display
MAIN WASH flashes.
The door is not correctly
closed. Close the door correctly.
Start the program again.
No water flows.
Fault code
E10
appears. The display
RINSE + flashes
Water tap is closed. Open the water tap.
Filter in screw connection of
the inlet hose is blocked.
Close the water tap. Unscrew
the hose from the tap,
remove the filter and clean
under running water