Electrolux 76639 - Manual (Page 22)

Operating Instructions
22
Starting the washing program
0 1. Check that the water tap is open.
2. Start the washing program:
Press the START/PAUSE button
The washing program is started or starts
at the end of the time delay set.
3 If the DOOR display flashes red when the START/PAUSE button is
pressed, the door is not properly closed.
– The display DOOR flashes red
– The error code E40 then flashes in the multi display
– And the MAIN WASH display flashes.
In this case, press the door firmly closed and again press the
START / PAUSE button.
If the delay timer has been set:
The start time delay set on the time delay counts down; the time
remaining until the program starts is displayed in the multi-display
(in hours remaining, e.g. 5h). During this time you can add washing and
change or stop the delay timer.
• Load the washing: Press the START/PAUSE button. The door can be
opened. Then close the door and press the START/PAUSE button
again.
• Changing or stopping delay timer: Press the DELAY TIMER button
repeatedly until the desired time is displayed. When the program
duration is displayed (display in minutes e. g.129) the washing
program starts without delay.
Washing Program Progress
Program progress display
Prior to the start, the program steps chosen are
displayed by the Program progress display.
During the washing program the current
program step is displayed.