Electrolux 76639 - Manual (Page 24)

Operating Instructions
24
Washing cycle is complete/Removing the washing.
Once the washing program has come to an end, END illuminates on the
program progress display.
If RINSE HOLD was selected, the display beside the START/ PAUSE
button flashes.
0 1. After a rinse hold, the water must first be pumped out:
– Either press the START/PAUSE button (the water is pumped out and
the washing is spun according to the completed program; After the
START/PAUSE button is pressed again, the spin speed can still also be
changed during spinning),
or
– Turn the program selector to PUMP OUT and press the START/PAUSE
button (the water is pumped out without spinning),
or
– Turn the program selector to SPIN or SHORT SPIN and press the
START/PAUSE button (the water is pumped out and the washing is
spun or gently spun).
At the end of this program step, the END indicator will illuminate.
2. Open the door.
As soon as the DOOR indicator lights up green, the door can be opened.
3. Remove the washing.
4. Turn the program selector to OFF.
5. Close the water tap.
6. After washing, pull out the washing detergent dispenser drawer slightly
so that it can dry out. Leave the door ajar so that air can circulate in
the drum.
3 If the OVERDOSING indicator illuminates, then too
much detergent was used in the washing program
just completed. Observe the dosing recommendations
of the detergent manufacturer as well as the load
quantity for the next wash.
Important! If the washing machine is not to be used for a long period:
Close the water tap and disconnect the washing machine from the
electricity mains.