Yaskawa MotionWorks IEC - Manual (Page 4)

Subject: Example Code Manual
Product: MP2300Siec and
MotionWorks IEC
Doc#: EM.MCD.08.011
Title: Feed-to-Length Application using MC_TouchProbe for Position Latching
October 24, 2008 Page 4 of 10
2. Quick Startup Procedure (Project transfer to controller)
I. Go to the ‘Hardware’ tab. (Fig 1)
II. Right click ‘Resource: MP2300Siec’ (Fig 1)
III. Under ‘Settings’, set the IP address of the controller
IV. Make the project (Fig 2)
V. Download the project to the controller through the resource icon (Fig 3)
VI. Set in Debug mode(Fig 3)
Figure 1: Setting IP address