beautypg.com

3 osd menu setup, Chapter, 1 control key general operation guide – EverFocus EZ630 User Manual

Page 18

background image

18

3

OSD MENU SETUP

This chapter introduces how to change RS485 ID and Baud Rate and to configure the camera
OSD menu.

STEPS
If you want to connect to the camera with a keyboard or other RS-485 - controller, please refer to
Section 3.2 RS485 ID & Baud Rate setting. Otherwise, please go to STEP 2.
Configure the camera, as described below:

3.1

Control Key General Operation Guide

Switch between Lens and Menu operation

Press and hold ( ~ 5 s) the joystick button for changing the operation mode of the
joystick. Red LED: Menu mode, Green LED lens control mode.


Bring Up the General OSD Menu

Simply press the mini-joystick to bring up the general OSD menu.

Note: Make sure, that the joystick is in "MENU" mode (red LED under Joystick).

Navigate among the OSD Menu Items

Angle the mini-joystick up ( ) or down ( ) to move the cursor up or down.


Change Modes or Setting Parameters

Angle the mini-joystick left ( ) or right ( ) to adjust the mode or value of settings.


Switch to Sub-menu Screens

When an item with a sub-menu is selected, press in on the mini-joystick to switch to the
sub-menu for further settings. This may also be referred to in the instructions below as
“pressing the setup button”. Please refer to the diagram below.















Chapter

3

Sub-Menu
s Menu

Main Menu

DC LENS

BRIGHTNESS |+++++++++| 45

RETURN RET

<┘

SETUP

EVERFOCUS


1. LENS DC

<┘

2. EXPOSURE

<┘

3. WHITE BAL. AWB
4. DAY NIGHT EXT
5. 3DNR ON

<┘

6. SPECIAL

<┘

7. ADJUST

<┘

8. RESET

<┘

9. EXIT