EverFocus EZ630 - Manual (Page 13)

13
2 INSTALLATION
This chapter will describe, in general terms, how to install the EZ610/630 camera.
STEPS:
1. Wire and mount the camera. See 2.1
2. Adjust the camera position. See 2.2
Warning
To prevent electrical shock, turn off the electrical power before making electrical connections.
2.1 Wiring and Mounting
Use the template and an appropriate tool to drill 4 holes to attach the speedy-mount ring. If no
surface wire will be used, please insert the provided plug into the ring from the underside; the
plug will be held securely in place by the ring. If surface wire access is required, simply omit the
plug to leave the surface wire channel clear.
Push the plastic anchors into the 4 holes.
3. Take a long Phillips pan head screw and tighten it through the EZ Mount Ring counter-bored
hole into a plastic anchor. Repeat this step until all 4 screws are secured to the wall/ceiling.
4. Drill a 1” diameter hole within the interior of the EZ Mount Ring.
5. Pull the cables to be connected to power & video cables from the ceiling or wall.
Chapter
2