SMA SB 4200TL HC Multi-String - Manual (Page 41)

SMA Technologie AG Technical Data
Installation Guide SBTLHCMS-IEN080411 Page41
8.4. 2 Parameter settings for Germany
Grayed out parameters are only displayed in installer mode. The table below contains
the parameters that are applicable in Germany. The Sunny Boys were prepared for the
DIN VDE 0126-1-1 in two steps. The table specifies the settings that are respectively
valid.
Uac-Tavg Averaging time of grid frequency gaging
Uzwk-Start The DC voltage required before the Sunny Boy begins feeding
power into the mains supply.
Usoll-Konst A PV desired voltage for constant operational voltage. These pa-
rameters are only important when the "Betriebsart" parameter is
set to U-konst.
Usoll-Konst B
Name Short
descr. Value range Factory setting
ACVtgRPro V 230 ... 300 253
AntiIsland-Ampl * grd 0 ... 10 0
AntiIsland-Freq * mHz 0 ... 2000 500
Betriebsart MPP, IKonst, UKonst,
Stopp, MPP
Default * GER/VDE0126-1-1,
IT/DK5950, Other,
trimmed GER/VDE0126-1-1
dFac-MAX * Hz/s 0.1 ... 4.0 4.0
dZac-MAX * mOhm 350 ... 20000 600
E_Total kWh 0 ... 200000 0
Fac-delta- * Hz 0.1 ... 4.5 2.45
Fac-delta+ * Hz 0.1 ... 4.5 0.19
h_Total h 0 ... 200000 0
Inst.-Code
LDVtgC V 0 ... 50 0
Ni-Test * 0 / 1 1
Ripple-Ctl-Frq Hz 110 ... 1605 1605
Ripple-Ctl-Lev % 0.5 ... 8.00 8
Name Explanation