SMA MATRIX Quick Reference Guide - Manual

Matrix_SEN103510 | 98-0040110 | Version 1.0
Plant Monitoring
SUNNY MATRIX
Quick Reference Guide - Creating a Slide Show
EN
Explanation of Display Areas:
A display area is made up of modules on the Sunny Matrix. A module consists of 4 positions. The
Sunny Matrix can display a character at each of these positions. You can compile display areas
with different lengths of these modules and positions. The Sunny Matrix modules are always
numbered from left to right, from top to bottom. The numbering is required for compiling the
display areas.
Display areas are already predefined before shipping the Sunny Matrix and noted for you on the
configuration sheet included in the delivery.
Normally every line with modules is predefined as a display area. The following example shows
the normally predefined display areas of a Sunny Matrix with 2 lines, with 4 modules, each.
Defining the display area (example):
The following display areas are to be defined:
• A display area is to be saved as [7] and made up of the following modules: module 1 with
positions 1 to 4, module 2 with positions 1 and 2.
• A display area is to be saved as [8] and made up of the following modules: module 2 with
positions 3 to 4, module 3 with positions 1 to 4 module 4 with positions 1 to 4.
1 Select Display > Configuration.
2 In the “Definable displays“ area select [7].
3 Defining the display area:
3.1
Activate the first selection field and select the following settings in the drop-down lists:
“Module“ 1, “Start“ 1, “Length“ 4.
3.2
Activate another selection field and select the following settings in the drop-down lists:
“Module“ 2, “Start“ 1, “Length“ 2.
4 Select [Save].
5 In the “Definable displays“ area select [8].
6 Defining the display area:
6.1 Activate the first selection field and select the following settings in the drop-down lists:
“Module“ 2, “Start“ 3, “Length“ 2.
6.2 Activate another selection field and select the following settings in the drop-down lists:
“Module“ 3, “Start“ 1, “Length“ 4.
6.3 Activate another selection field and select the following settings in the drop-down lists:
“Module“ 4, “Start“ 1, “Length“ 4.
7 Select [Save].
SMA Solar Technology AG
Sonnenallee 1
34266 Niestetal, Germany
www.SMA.de
SMA Serviceline
Inverters: +49 561 9522 1499
Communication: +49 561 9522 2499
Fax: +49 561 9522 4699
E-Mail: [email protected]
If you have technical problems concerning our products, contact the SMA Serviceline. We
require the following information in order to provide you with the necessary assistance:
• Type of inverter
• Type of communication interface between Sunny WebBox and the inverters
• Sunny Matrix firmware version
• Sunny Matrix serial number of the system board
• Sunny Matrix serial number
CoNTACT
DEFINING THE DISPLAY AREAS
A
Numbering of modules and positions:
Module
Display Area [1]
Display Area [7]
Display Area [2]
Display Area [8]
Position