SMA PT100M-NR - Manual (Page 13)

SMA Solar Technology AG Decommissioning
Installation Guide PT100MNR-IEN083510 13
6 Decommissioning
6.1 Uninstalling the Sensor
1. Reset the configuration of the sensor in the communication device.
2. Detach the sensor cable from the communication device.
☑ The sensor is now uninstalled.
6.2 Disposing of the Sensor
At the end of the service life of the PV system, dispose of the sensor in accordance with the disposal
regulations for electronic waste applicable at the installation site at that time. Alternatively, send it
back to SMA Solar Technology with shipping costs paid by sender, and labeled
"ZUR ENTSORGUNG" ("for disposal")
7 Technical Data
8 Accessories
ATTENTION!
Damage to the solar cell due to detaching the module temperature sensor
Sensors should not be removed once affixed as this could cause damage to the solar cell.
The sensor cannot be reused.
• Cut the sensor cable directly from the sensor.
General data
Measurement resistor
PT100
Installing the Device outdoors
Protection rating IP62
Connection cable
Connection cable
pre-configured cable length of 2.5 m.
Measured values
Tolerance
maximum ± 0.7 °C (class B)
Measuring range -20 °C to +110 °C
Warranty, Certificates and Permits
Warranty
2 years
Description SMA order number
Analog IN connection
terminal block 25-pin, D-Sub plug for Sunny Boy Control Plus
(incl. 1:1 cable, 25-pin D-Sub, bushing/plug,
length 0.5m) SBCOP-ANA-KIT