SMA 485PB-NR - Manual (Page 7)

SMA Solar Technology AG Unpacking
Installation Guide 485PB-SB-NR-IEN101311 7
3 Unpacking
3.1 Packing List
3.2 Identification
You can identify the communication interface by the type label. The type label is located on one of
the socket connectors of the communication interface.
Position Number Description
A
1 RS485 Piggy-Back: 485PB-G3
B 1 Jumper
C 1 Shield clamp
*
*
Is only required for SB/WB 3300 and SB/WB 3800 inverter models.
D 1 Screw for fastening the shield clamp
*
E 1 Contact disk
*
F 2 Insulating tubes
G 2 Conductive bonding sheets
*
H 1 Cable tie
I 1 Flat cable connector
K 2 Cable glands (with single seal insert)
L 1 Cable gland (with double seal insert)
M 2 Counter nuts for the cable glands
N 1 Installation guide with RS485 cabling plan poster