ShoreLand'r PVB1412 V.1 - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003881
Page 6 Rev A 06/14/2011
Bunk
Mount the saddle brackets to the frame using 3/8” x 1-15/16” x 4”
square u-bolts from the bottom side of the frame and up through
the saddle bracket. Secure with 3/8” flat washers, 3/8” lock wash-
ers, and 3/8” hex nuts. Refer to Detail D for placement.
Mount the bunk to the saddle brackets on the frame using 1/4” x 1-
1/2” self-tapping screws. About 4” of the bunk will protrude out the
back of the trailer, measuring from the taillight bracket.
Assembly should be complete except for tightening some of the
bolts. These bolts were left loose only to aid in adjusting the trailer
to the boat. All bolts and nuts must be tightened before towing!
NOTE: The law requires that the white ground wire on both the
tongue wire harness and vehicle harness must be properly ground-
ed to the trailer and vehicle frames.