ShoreLand'r LUV28BXXL V.2 - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003837
Page 6 REV B 02/05/2009
WINCH POST INSTALLATION
The height that the bow eye is placed in your boat will determine
the length winch post required. Once this is determined, attach the
winch base to the tongue with three 1/2” x 4-1/2” carriage bolts and
lock nuts.
Align the holes in the Profile 2000 mounting channel with the holes
in the top of the winch base. Attach the front of the winch head
mounting channel to the base by placing a 1/2” x 4-1/2” hex bolt
through the hole closest to the front of the winch base. Secure with
a lock nut. Do not tighten.
Note that the winch head can now be rotated either up or down.
Identify the correct hole combination to use to position the bow eye
roller just above the bow eye of your boat. When determined, se-
cure in this position by placing the bushing as shown in Diagram C
inside the winch base so it aligns with the hole just identified for the
proper adjustment. Insert another 1/2” x 4-1/2” hex bolt through the
determined mounting hole in the mounting channel and winch base
making sure the bolt passes through the bushing as well. Secure
with a 1/2” lock nut. Tighten all bolts.
SPRINGS
Position the axle so it is properly aligned with the trailer and the
calipers are on the back side of the axle as shown.
Place the springs on the topside of the spring pads welded to the
axle. (See Diagram E). Note that the hook end of the spring must
be mounted to the rear of the trailer. Place a spring clamp on the
top center of the spring as shown. Next place the 1/2” x 6-1/2”
U-bolts down over the top of the spring clamp, spring and axle as