ShoreLand'r LUV30BLW V.1 - Manual (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003669
Page 10 REV D 01/23/2009
EQUILOAD DOUBLE BUNK ASSEMBLY
Locate the carpeted bunks. Lay two of them upside down on the
floor so they are spaced approximately 3 ½” apart. Remove the
nuts and lock washers from the bolts that are in the bunks.
Locate two of the double bunk brackets. Position them upside down
so that the holes in the double bunk brackets align with the bolts
from which the nuts were just removed. Drop into position and se-
cure with the lock washers and hex nuts just removed. Tighten but
do not over tighten because they may have to be adjusted to fit the
trailer cross members.
Turn the bunk assembly upright and place on the trailer so that the
double bunk brackets drop down around the cross members so
one leg of the brackets is on each side of the cross member. Align
the proper hole in the double bunk brackets with the correct hole
in the cross members. Insert a 3/8” x 3 ¾” hex bolt into the aligned
holes. Secure with a 3/8” flange lock nut. Tighten. Tighten the nuts
left slightly loose when assembling the bunks.
Repeat the above process on the bunks for the other side of the
trailer.