ShoreLand'r LUR22L V.2 - Manual (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003666
Page 10 of 10 REV C 3/23/2011
JACK ASSEMBLY AND INSTALLATION INSTRUCTIONS
It is recommended that the jack be mounted on the right side of the tongue. This will place it on the
opposite side of the winch handle to eliminate the possibility of the two interfering when being
operated.
Remove the hardware bag from the jack and sort all items by size.
Note that the jack mounting plate has only one pair of holes on one side of the plate while the other
side has holes punched to accommodate either 3”, 4”, or 5” tongue.
Place a 3/8” x 4” hex bolt into the single hole of the mounting plate so the head of the bolt is on the
jack side of the plate.
Once inserted, place one of the mounting channels onto the bolt so the legs of the mounting channel
are pointing away from the jack. Place on a 3/8” flat washer and hex nut. Thread on only far enough
to secure in place.
Repeat the above process on the other single hole of the mounting plate.
Place the jack on the tongue so that the two bolts just installed are on the top side of the tongue with
the jack on the right side of the tongue and the mounting channels on the other side of the tongue.
Visually check which of the bottom three holes in the plate will align just under the bottom side of the
tongue. Insert the remaining two 3/8” x 4” hex bolts into these holes and then through the mating
holes in the mounting channel. Secure with 3/8” flat washers and hex nuts.
Rotate the jack into the up position. Slide the jack forward or backward on the tongue to make sure it
will not hit the frame of the trailer when in the up position.
Tighten all of the mounting bolts to secure the jack assembly to the tongue.
Always rotate the jack in the up position before towing the trailer.