ShoreLand'r LUB14TM V.1 - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003663
Page 3 REV B 07/28/2011
TONGUE ASSEMBLY
Place the frame to be assembled on saw horses or stands to assist
in the assembly. Remove all items that are banded to the frame.
Sort the items in the hardware box by item and the hardware by
size.
Locate the tongue for the trailer.
See Diagram A
Place tongue on the stands so it can be prepared for installation
into the frame. Locate the two amber side marker lights shipped in
the hardware box. Uncoil the wire and insert the plug end into the
larger, center hole that is drilled in the side of the tongue. As the
wire is inserted into the hole direct the wire so that it will go to the
forward end of the tongue. Pull the wire out the front of the tongue.
It will be connected to the tongue harness at a later time. Attach the
light to the tongue using two (2) No. 10 x 3/4” self-tapping screws
provided. Repeat this process on the other light on the other side
of the tongue.
Locate the tongue wire harness. Insert the end of the harness with
the small plug into the hole located in the top of the tongue. Pull
the wire backward through the tongue until the end comes out the
rear of the tongue. As the wire harness is inserted note that there
are two single bullet wires towards the front plug of the tongue wire
harness. Pull these wires forward as the wire harness is inserted
into the tongue. Plug the single wires from the side marker lights
installed earlier into the two single bullets of the tongue harness.
Push the additional back into the front of the tongue to keep it from
damage during use. Place a rubber grommet around the wire har-
ness and in the hole in the top of the tongue to protect the wires
from damage during use.
Route the harness plug at the rear of the tongue through the hole
provided in the side of the tongue. Pull both the plug and the white
ground wire out the hole. They will be attached later once the
tongue is installed in the frame.
Locate the safety chains. Place a 3/8” flat washer on a 3/8” x 1-1/4”
hex bolt. Insert the bolt through the last link in the safety chain and
then into the lower hole provided in the front of the tongue. Secure
with a 3/8” flange lock nut. Tighten. Repeat on the other chain.
Place the coupler on the top of the tongue. Align the holes in the
coupler with the holes in the tongue. Place a 1/2” x 4” hex bolt
through the back holes of the coupler and the tongue. Secure with
a 1/2” flange lock nut but do not tighten at this point.
Place a 1/2” x 1” hex bolt through the front hole on one side of the
coupler and the tongue so that the head of the bolt is to the outside.
Place a 1/2” flange lock nut on the bolt inside the tongue. Repeat
this process on the other side of the tongue. Once the bolts are
installed, tighten all nuts left loose at this time.
Insert the tongue assembly through the front channel of the frame
far enough so the rear of the tongue is inserted into the front cross
member. Align the cross hole in the front channel and the tongue