ShoreLand'r LAV22L V.1 - Manual (Page 7)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004174
Page 7 Rev A 09/29/2011
SPRINGS
Positions the axle so that it is aligned with the trailer.
Place the springs on the top side of the spring pads welded to the axle.
(See chassis diagram on page 4.) The hook end of the spring must be
mounted to the rear of the trailer. Place a spring clamp on the top center
of the spring. Place the 1/2” X 6-1/2” U-bolts over the top of the spring
clamp, spring and axle. Place the spring and axle U-bolt plate onto the
ends of the two U-bolts. Secure in place with 1/2” lock nuts. Tighten.
AXLE
Place a spring bracket bushing (Ref.#9, Detail E) into the rear of the
spring bracket and secure with a 9/16” x 3-1/4” hex bolt and hex lock nut.
Repeat in the other spring bracket. Position the axle under the frame,
hook the hook loop of the spring around the bushings just installed.
Note: If the axle is positioned too low, the hooks will not hook around the
bushings.