ShoreLand'r SLIB31B - Manual (Page 8)

Chassis 74” Wide W/Tandem 9” Fenders Bill of Material
Assembly Instructions
Springs:
Mount the springs to the axle with the 1/
2” X 2-5/16” X 6-1/2” axle u-bolts from the
top down. Install the 4” spring clamp on
the top of the spring under the u-bolts.
Install the 4X4 clamp under the axle.
Tighten the 1/2” flange lock nuts.
Axle:
Place one (1) of the spring bushing into
the rear of the spring bracket and secure
with a 9/16” X 3-1/4” hex bolt and 9/16”
hex nut. Repeat on the other side. Posi-
tion the axle under the frame, then hook
the spring loop around the bushing just
installed. Raise the axle assembly up so
that the front of the springs line up with
the front of the spring bracket hole. Insert
the 9/16” X 3-1/4” hex bolts and 9/16” hex
nuts. Tighten all nuts and bolts but do not
over tighten. Allow the spring room
enough to move.
Mount the tire and rim assemblies using
80 - 90 ft. lbs. of torque on the lug nuts
using a proper tightening procedure.
Brakes:
Refer to the brake manual for service and
maintenance instructions.