ShoreLand'r BK2200US-R V.1 - Manual (Page 2)

BK2200US-R
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com 0003187
Page 2 of 6
Tools Required for Assembly
9/16” Wrench / Socket 7/8” Wrench / Socket
13/16” Wrench / Socket 3/4” Wrench / Socket
5/16” Socket
Safety Chain:
Insert 3/8” X 1-1/4” hex bolt (REF.#4) with 3/8” flat washer
(REF.#16) and safety chain (REF.#25) through the lower hole
on front of tongue. Secure with 3/8” flat washer and 3/8” flange
lock nut (REF.#20) Repeat procedure on opposite side of
tongue.
Coupler:
Mount coupler (REF.#26) to tongue using two (2) 1/2” X 1”
hex bolt (REF.#9) to front holes and one (1) 1/2” X 4” hex bolt
(REF.#5) in rear hole of coupler. Secure with 1/2” flange lock
nuts. (REF.#21).
Axle/Springs:
Mount leaf spring (REF.#41) to axle assembly using two (2)
1/2” X 5/16” X 5-3/4” square u-bolts (REF.#11) over the spring
clamp (REF.#52) and spring. Secure this spring to the axle
assembly using a spring plate (REF.#53) and four (4) 1/2”
flange lock nuts (REF.#21).
Install spring bracket bushing (REF.#51) and 9/16” X 3-1/4”
hex bolt (REF.#7) into rear frame spring shackle. Secure with
9/16” hex nut (REF.#22). Hook leaf spring (REF.#41) on axle
assembly over bushing just installed. Insert 9/16” X 3-1/4”
hex bolt in eye of leaf spring and secure into front frame spring
shackle. Tighten all four bolts on both sides on of trailer to
secure the axle assembly to the under carriage of the trailer.
Tires:
Remove stud thread protectors. Mount tires (REF.#33) to hubs
(REF.#40) using 1/2” lug nuts (REF.#19).
Caution:
1. To prevent damage to your utility trailer or
towing vehicle, tighten all fasteners before
towing.
2. Your utility trailer is equipped with a totally
grounded wire harness. You must be sure
the wire harness plug that comes from the
tow vehicle is grounded to the tow vehicle
using the white grounding wire.
3. Always secure (tie) your load down before
towing.
Assembly Instructions