ShoreLand'r 2200U - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003618
Page 6 2/02/06
Tools Required for Assembly
9/16” Wrench / Socket 7/8” Wrench / Socket
13/16” Wrench / Socket 3/4” Wrench / Socket
5/16” Socket
Assembly Instructions
Safety Chain:
Insert 3/8” X 1-1/4” hex bolt with 3/8” flat washer and safety
chain through the lower hole on front of tongue. Secure with
3/8” flat washer and 3/8” flange lock nut. Repeat procedure
on opposite side of tongue.
Coupler:
Mount coupler to tongue using two (2) 1/2” X 1” hex bolt
to front holes and one (1) 1/2” X 4” hex bolt in rear hole of
coupler. Secure with 1/2” flange lock nuts.
Axle/Springs:
Mount leaf spring to axle assembly using two (2) 1/2” X 5/16”
X 5-3/4” square u-bolts over the spring clamp and spring.
Secure this spring to the axle assembly using a spring plate
and four (4) 1/2” flange lock nuts.
Install spring bracket bushing and 9/16” X 3-1/4” hex bolt into
rear frame spring shackle. Secure with 9/16” hex nut. Hook
leaf spring on axle assembly over bushing just installed.
Insert 9/16” X 3-1/4” hex bolt in eye of leaf spring and secure
into front frame spring shackle. Tighten all four bolts on both
sides on of trailer to secure the axle assembly to the under
carriage of the trailer.
Tires:
Remove stud thread protectors. Mount tires to hub using
1/2” lug nuts.
Caution:
1. To prevent damage to your utility trailer or
towing vehicle, tighten all fasteners before
towing.
2. Your utility trailer is equipped with a totally
grounded wire harness. You must be sure
the wire harness plug that comes from the
tow vehicle is grounded to the tow vehicle
using the white grounding wire.
3. Always secure (tie) your load down before
towing.