ShoreLand'r PWC1400 V.2 User Manual

Page 3

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0003602

REV A 2/14/06

Assembly Instructions:

Remove all small parts from the frame by cutting the bands.

Remove the bolt bag and sort all nuts and bolts by size.

Tongue:

Remove the tongue assembly from the frame bundle and

slide into the tongue channel. Secure with a 3/8” X 4” car-

riage bolt in the front and 3/8” X 3-7/16” X 4-1/8” square

u-bolt, 1” X 4-1/2” mounting strap and 3/8” ﬂange lock nut

in rear of the assembly. Thread the tongue wire harness

through the tongue and connect to the frame harness and

install the grommets.

NOTE: Install the tongue in one of the

two adjustment holes in the tongue channel. Refer to the

parts drawing for placement.

Safety Chain:

Insert a 3/8” X 1-1/4” hex bolt with a 3/8” ﬂat washer and

safety chain through the lower hole on the front of the tongue.

Secure with a 3/8” ﬂat washer and 3/8” ﬂange lock nut. Re-

peat this procedure on the opposite side of the tongue.

Coupler:

Mount the coupler onto the tongue with one (1) 1/2” X 4” hex

bolt and two (2) 1/2” X 1” hex bolts. Secure with 1/2” ﬂange

lock nuts.

Winch Post:

Attach the winch brace to the winch post assembly with a

3/8” X 4” hex bolt in one (1) of the three (3) holes of ad-

justment. Position the winch assembly on the tongue in a

location that will best ﬁt your watercraft. Fasten with 3/8” X

3-7/16” X 4-1/8” square u-bolt, 1” X 4-1/2” mounting straps

and 3/8” ﬂange lock nuts.

Axle:

Install the spring bushing in the rear spring bracket with 1/2”

X 3-1/4” hex bolts and 1/2” ﬂange lock nuts. Position the axle

under the trailer with the spring eye to the front. Slip the ﬂat

end of the spring in the rear spring bracket and fasten the

front spring eye to the front of the spring bracket with 9/16” X

3-1/4” hex bolts and 9/16” hex lock nuts.

Mount the tire and rim assemblies with 1/2” lug nuts and

tighten to 80-90 ft./lbs. of torque.

Bunk:

Slide a 3/8” X 2-7/16” X 2-3/4” square bolt over the rear

cross member with the threads facing the

FRONT. Place an

adjustable bunk bracket on the u-bolt legs and secure with

3/8” ﬂange lock nuts. Slide a 3/8” X 2-7/16” X 2-3/4” square

u-bolt over the front cross member with the threads facing