ShoreLand'r PWC1000L V.2 - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0002990
Page 3 REV B 02/14/06
Bunk:
Slide a 3/8” X 2-7/16” X 2-3/4” square bolt over the rear cross mem-
ber with the threads facing the REAR. Place an adjustable bunk
bracket on the u-bolt legs and secure with 3/8” flange lock nuts.
Slide on a 3/8” X 2-7/16” X 2-3/4” square u-bolt over the front cross
member with the threads facing the FRONT. Place an adjustable
bunk bracket on the u-bolt legs and secure with 3/8” flange lock
nuts. Fasten the bunk assembly to the adjustable bunk brackets
just mounted and secure with 3/8” X 1” hex bolts and 3/8” flange
lock nuts.
CAUTION:
To prevent damage to your water vehicle hull, place the water ve-
hicle on the trailer, loosen bunk u-bolts so the bunks conform to the
hull. Tighten.
Tighten all fasteners before towing.
The law requires that the white wire on both the tongue and vehicle
wire harness be grounded to the trailer and towing vehicle.
Coupler:
Mount the coupler onto the tongue with one (1) 1/2” X 4” hex bolt
and two (2) 1/2” X 1” hex bolts. Secure with 1/2” flange lock nuts.
Winch Post:
Attach the winch brace to the winch post assembly with a 3/8” X 4”
hex bolt in one (1) of the three (3) holes of adjustment. Position the
winch assembly on the tongue in the desired position and fasten
with a 3/8” X 3-7/16” X 4-1/8” square u-bolts, 1” X 4-1/2” mounting
straps and 3/8” flange lock nuts.
Axle:
Install the spring bushing in the rear spring brackets with 1/2” X 3-
1/4” hex bolts and 1/2” flange lock nuts. Position the axle under the
trailer with the spring eye to the front. Slip the flat end of the spring
in the rear spring bracket over the bushing and fasten the front
spring eye to the front of the spring bracket with 9/16” X 3-1/4” hex
bolts and 9/16” hex lock nuts.
Mount the tire and rim assemblies with 1/2” lug nuts and tighten to
80-90 ft./lbs. of torque.